Dwin 2 Instructions d'exploitation télécharger pdf (Page 37)

Lamp Replacement Procedure

CAUTION!

Take the following precautions to prevent electric shock, burns and injuries

from broken glass.

The projection lamp operates at very high pressures and temperatures. Some

lamp failures may result in the projection lamp shattering. To prevent injuries

from shattered glass, use caution when removing the lamp assembly from its

housing. Do not touch the lamp with bare hands

For lamp replacement, turn off the power, unplug the AC cord, allow lamp

at least 30 minutes to reach room temperature.

To Replace Lamp:

1. Remove two bottom screws to remove the plastic cover.

2. Gently loosen but do not remove the top middle screw indicated by the

arrows.

3. Use the handle to pull the lamp assembly out of housing.

4. Insert new lamp assembly into housing. Note the location of the lamp con

nector and insert the lamp assembly in the proper direction.

5. Gently tighten top middle screw.

6. Replace plastic cover and fasten bottom two screws.

External Plastic Cover

> <

CAUTION!

LAMP IS HOT

CAUTION!

LAMP IS HOT

Lamp Assembly

Screw

Handle

Lamp Connector

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 43

Pas de commentaire

Dwin 2 Instructions d'exploitation Page 37