Dwin TransVision 3 Enhanced Instructions d'exploitation télécharger pdf (Page 29)

2C. Ceiling Mount Installation and Projector Mounting

The optional ceiling mount kit (CMB) consists of three parts. Before beginning

the installation process, ﬁrst identify each of the three parts of the mounting

system as shown in the pictures below.

NOTE: The ceiling must be capable of safely supporting the weight of the

projector and mount, which is approximately 25 pounds.

Ceiling Mount Kit

Ceiling Bracket A

Ceiling Bracket B

Ceiling Assembly C

Do Not Remove Hex Nuts!

1. Disassemble the Ceiling Mount Kit by removing and saving the two rear hex

screws located on both sides of the Ceiling Mount Kit.

2. Loosen the middle two hex screws and slide out from the “L” shaped groove

brackets “A” and “B” as a unit.

3. On bracket “A”, remove and save all four hex head screws and separate

bracket “A” from bracket “B”.

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 38 39

Pas de commentaire

Dwin TransVision 3 Enhanced Instructions d'exploitation Page 29